Press Ctrl / CMD + C to copy this to your clipboard.
This post will be reported to the moderators as potential spam to be looked at
Hi,
I've had a question raised by a customer regarding a property that doesn't seem to exist in the application.
The manual they are using is at:
http://websupport.surgery.ucsf.edu/media/3375338/umbraco-v4---editors-manual-v1.0.0.pdf
On page 22, it shows that there's a property called 'Constrain Proportions' but this property isn't shown when working with Umbraco version 4.7.1.1. Is this an error in the manual or is there a way to get this property to show?
Thanks in advance.
Alan
It looks like it's an old screenshot. I think that the contrain is always enabled and the checkbox has been removed.
Jeroen
Thanks Jeroen - that's as I suspected but just wanted to make sure I wasn't missing anything here!
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.
Continue discussion
Umbraco Editor Manual v4 - missing property?
Hi,
I've had a question raised by a customer regarding a property that doesn't seem to exist in the application.
The manual they are using is at:
http://websupport.surgery.ucsf.edu/media/3375338/umbraco-v4---editors-manual-v1.0.0.pdf
On page 22, it shows that there's a property called 'Constrain Proportions' but this property isn't shown when working with Umbraco version 4.7.1.1. Is this an error in the manual or is there a way to get this property to show?
Thanks in advance.
Alan
It looks like it's an old screenshot. I think that the contrain is always enabled and the checkbox has been removed.
Jeroen
Thanks Jeroen - that's as I suspected but just wanted to make sure I wasn't missing anything here!
Alan
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.