Press Ctrl / CMD + C to copy this to your clipboard.
This post will be reported to the moderators as potential spam to be looked at
Hi:
I'm currently writing a package for a client.
When the package is installed I'd ideally like to set up- some elations between data types, and extend the default member type.
Is thee a way to do this in the xml as it sands or do I need to write some code to allow code to be run during package installation?
Any help apreciated.
Cheers
Sean.
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.
Continue discussion
Running code when a package is installed
Hi:
I'm currently writing a package for a client.
When the package is installed I'd ideally like to set up- some elations between data types, and extend the default member type.
Is thee a way to do this in the xml as it sands or do I need to write some code to allow code to be run during package installation?
Any help apreciated.
Cheers
Sean.
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.
Continue discussion