I have a wired problem. I added a new application and couple tree nodes to the source code. When I run, I can see my new application/section show up on the navigation, but I have no tree nodes display.
From debugging, it seemed to me that Umbraco is locating those from cache. I don't see it is getting my new tree nodes from cache. Umbraco isn't caching my new trees. How can I tell if caching is broken?
Tree Nodes aren't showing
Hello,
I have a wired problem. I added a new application and couple tree nodes to the source code. When I run, I can see my new application/section show up on the navigation, but I have no tree nodes display.
From debugging, it seemed to me that Umbraco is locating those from cache. I don't see it is getting my new tree nodes from cache. Umbraco isn't caching my new trees. How can I tell if caching is broken?
Best, -Don
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.