Press Ctrl / CMD + C to copy this to your clipboard.
This post will be reported to the moderators as potential spam to be looked at
Hi
I have turned on the following in umbracoSettings.config:
<errors> <error404>1024</error404> </errors>
Wich should give me an Umbraco page to handle the 404 requests.
But, instead I just get the standard IIS error:
"Server Error
404 - File or directory not found.
The resource you are looking for might have been removed, had its name changed, or is temporarily unavailable."
I can see the page if I call it directly on the http://domain.com/1024
We have configured Umbraco to remove the .aspx extensions, should that be of any difference or did I miss something in the IIS configuration?
Regards
Are you using IIS 7? If so, have a look here:
http://our.umbraco.org/forum/using/ui-questions/8244-IIS7--404
Thanks alot!
I use IIS 7.5 but the same did the trick.
Just wiched that I didn't have to config the IIS manually, but it works!
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.
Continue discussion
Umbraco not handling 404 requests
Hi
I have turned on the following in umbracoSettings.config:
Wich should give me an Umbraco page to handle the 404 requests.
But, instead I just get the standard IIS error:
"Server Error
404 - File or directory not found.
The resource you are looking for might have been removed, had its name changed, or is temporarily unavailable."
I can see the page if I call it directly on the http://domain.com/1024
We have configured Umbraco to remove the .aspx extensions, should that be of any difference or did I miss something in the IIS configuration?
Regards
Are you using IIS 7? If so, have a look here:
http://our.umbraco.org/forum/using/ui-questions/8244-IIS7--404
Thanks alot!
I use IIS 7.5 but the same did the trick.
Just wiched that I didn't have to config the IIS manually, but it works!
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.