I have installed the latest WebPI version of Umbraco and get the login screen for the admin and it will not take the password I set up during install. Any ideas?
The problem ended up being that the part of setting up Umbraco had not been done yet. I found the admin link in some documentation and went straight there before setting up the Umbraco config. Apparently the Umbraco config would not come up on this server until I added it to trusted sites. I was then able to go through the Umbraco initial setup and the admin link worked fine after that. Thanks for following up!
Admin Password No Work
I have installed the latest WebPI version of Umbraco and get the login screen for the admin and it will not take the password I set up during install. Any ideas?
Hi Deron
Are you sure it's the same password you're trying to enter as the one you created the instance of Umbraco with?
/Jan
The problem ended up being that the part of setting up Umbraco had not been done yet. I found the admin link in some documentation and went straight there before setting up the Umbraco config. Apparently the Umbraco config would not come up on this server until I added it to trusted sites. I was then able to go through the Umbraco initial setup and the admin link worked fine after that. Thanks for following up!
Hi Deron
Good to hear you got it all figured out and a well deserved Hi5 for telling about what caused the issue and how you got it solved.
/Jan
Thanks Jan! (Don't tell anyone but I already voted you in as one of the MVP's) :)
Haha, thanks a bunch! I'm very honoured :-)
/Jan
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.
Continue discussion