Sign in Register
Go to solution
Copied to clipboard

Flag this post as spam?

This post will be reported to the moderators as potential spam to be looked at


  • Jose Badia 13 posts 156 karma points
    Oct 19, 2015 @ 15:30
    Jose Badia
    0

    Backoffice tree does not load after upgrade to 7.3.0

    Installing umbraco
    Umbraco 7

    I tried to upgrade from 7.2.8 to 7.3.0 using Nuget. After I upgraded, when I open the backoffice, neither the node tree nor the content of the Get Started tab loads initially. When I click on one of the left menu buttons, e.g., "Content", the corresponding tree opens. Similarly, when I click on a node, the tabs change on the page, but the tab's content does not load. Only when I click on the tab, the content of the tab is displayed. The screenshot below shows the backoffice when I access it. Any help would be much appreciated. Empty Backoffice

    Copy Link
  • Jose Badia 13 posts 156 karma points
    Oct 19, 2015 @ 17:22
    Jose Badia
    101

    This seems to have been caused by a cache. The problem seemed to resolve itself. My apologies.

    Copy Link
Please Sign in or register to post replies

Write your reply to:

Draft