Copied to clipboard

Flag this post as spam?

This post will be reported to the moderators as potential spam to be looked at


  • Ricky Beard 61 posts 116 karma points
    Jun 29, 2010 @ 20:31
    Ricky Beard
    0

    Package Creation and Installation problems in 4.5

    I have a very simple package that I created from an Umbraco installation that was upgraded from 4.0.4.2 to 4.5. I first noticed that the XSLT files were not automatically included in the package and needed to be added to the file list like an assembly.

    Then, when I installed the package onto a fresh 4.5 installation, none of the included content nodes were installed even though they are present in the package.xml file. Any suggestions?

  • bob baty-barr 1180 posts 1294 karma points MVP
    Jun 29, 2010 @ 22:39
    bob baty-barr
    1

    i too experienced the xstl file not being grabbed -- you can add it through the file maintenance area of the packager. i have not worked much with using content in a package.

    there is an issue on codeplex for the xslt issue... go vote it up :P

    http://umbraco.codeplex.com/workitem/27864

     

  • Ricky Beard 61 posts 116 karma points
    Jun 30, 2010 @ 17:05
    Ricky Beard
    0

    Thanks Bob, I voted the item up on Codeplex.

    As far as content goes, I wonder if it has anything to do with the new xml schema in 4.5. Has anyone tried to load content from a package generated from 4.5?

  • dandrayne 1138 posts 2262 karma points
    Jun 30, 2010 @ 18:25
    dandrayne
    0

    Hi Ricky

    I've made a workitem for the content issue - I'm experiencing this as well.  Vote it up at http://umbraco.codeplex.com/workitem/27929/ !

    Cheers,
    Dan

  • Ricky Beard 61 posts 116 karma points
    Jun 30, 2010 @ 18:28
    Ricky Beard
    0

    Voted... and I'm going to mark that as the solution.

    Thanks Dan!

Please Sign in or register to post replies

Write your reply to:

Draft