Umbraco (umbraco v 4.0.3 (Assembly version: 1.0.3625.27276))
When I save and publishes a node, it sometimes doesn't publish correct, and I have to republish the entire site (The option on the root node in the nodetree).
Is this a know issue? If so, are there a fix for this besides upgrading?
From my understanding, it's because the cached XML site strukture document isnt updated correctly, and when a publish entire site is performed, the XML is cleared and rebuild. But maybe this understanding is wrong.
I had a similar experience with Umbraco 4.5.2. The content for the page just didn't show up on the published page only on the preview page (even after numerous publish attempts).
But a republish entire site on the root node did the trick.
Nodes does not publish correct
Umbraco (umbraco v 4.0.3 (Assembly version: 1.0.3625.27276))
When I save and publishes a node, it sometimes doesn't publish correct, and I have to republish the entire site (The option on the root node in the nodetree).
Is this a know issue? If so, are there a fix for this besides upgrading?
From my understanding, it's because the cached XML site strukture document isnt updated correctly, and when a publish entire site is performed, the XML is cleared and rebuild. But maybe this understanding is wrong.
//Gretings
Mads
I had a similar experience with Umbraco 4.5.2. The content for the page just didn't show up on the published page only on the preview page (even after numerous publish attempts).
But a republish entire site on the root node did the trick.
Cheers,
Nis
Interesting to see that there are others that are experiencing the same problem as me.
See this thread.
I haven't found a solution to the problem yet despite quite a lot of testing and looking for possible sources for this behavior.
/Thomas Kahn
I have not experienced the problemer after I did the 'publish entire site'. But its not a site I use that much.
I found a solution that worked for me - published it in the other thread.
Just to clarify: my problem was the same problem that Nis had with the 4.5.2 installation.
/Thomas
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.