Hi Doug, is this in the "save as umbraco document' workflow ?

I've just tried it and it works fine in my test.

Would it be possible to share a screenshot of your form? That way I can setup the same form and try again.

Cheers,
Tim

Thank, Tim. Here's what I did...

1. I created an 'FAQ Item' docType with 3 textfield properties (yourName, yourEmail, answer).
2. I then created a Contour Form with 3 textfield properties (Your Name, Your Email, Your Question). Each is madatory. Save the form.
3. Add new 'When the form has been submitted' workflow (there are no pre-defined workflows so this is the only one there will be).
4. The workflow type is "save as umbraco document". Select the 'FAQ Item' docType.
5. Four fields appear in the 'Map document fields' section (Node name, Your Name, Your Email, Answer).
6. Each of these fields has a drop-down list with two entries: 'Choose...' and 'Enter static value'
7. Selecting 'Choose...' does nothing. Nothing appears.
8. Entering something in as a static value works properly and the values are passed through.

However... this morning the app pool restarted on the site and I had to log in again to the site

1. I removed the static text entries I tried last night and left the four fields blank
2. Click the Update button
3. Open the workflow for editing again, select 'Choose...' and the docType properties are listed properly.

Go figure.

Thanks again for your prompt attention. If I can reproduce this again I'll let you know.

cheers,
doug.

This problem has not happened again so it seems it was some kind of quirk on my particular installation.

cheers,
doug.

is working on a reply...