I've recently upgraded a working Contour 1.1.9 installation to Contour 1.1.12 (manual upgrade). Workflows were sending emails successfully using bracket syntax {email}. However now this isn't working.
If I update the same workflow to send directly to my personal email it works. But if I use bracket syntax (and still enter my email address) it doesn't work.
I've check the BADMAIL folder nothing in there. I've switched on IIS6 logging nothing in there. Nothing in the event log and nothing that I can see in the umbracolog database table.
Hey Paul, I just tried this in Umbraco 4.8.0 with Contour 1.1.12 installed. I do not get any emails when I'm in trial mode but as soon as I install the license it works fine.
Are you sure the fieldname hasn't changed or anything?
Bracket syntax not working with email
I've recently upgraded a working Contour 1.1.9 installation to Contour 1.1.12 (manual upgrade). Workflows were sending emails successfully using bracket syntax {email}. However now this isn't working.
If I update the same workflow to send directly to my personal email it works. But if I use bracket syntax (and still enter my email address) it doesn't work.
I've check the BADMAIL folder nothing in there. I've switched on IIS6 logging nothing in there. Nothing in the event log and nothing that I can see in the umbracolog database table.
Ideas?
Hey Paul, I just tried this in Umbraco 4.8.0 with Contour 1.1.12 installed. I do not get any emails when I'm in trial mode but as soon as I install the license it works fine.
Are you sure the fieldname hasn't changed or anything?
is working on a reply...