Sign in Register
Copied to clipboard

Flag this post as spam?

This post will be reported to the moderators as potential spam to be looked at


  • kim Thomsen 59 posts 277 karma points
    Nov 07, 2013 @ 11:33
    kim Thomsen
    0

    Contour install error

    Hi Peeps

    When installing Contour 3.0.17 on umbraco 4.11.8

    We getting the following error

    • web.config could not be updated + 
      System.NullReferenceException: Object reference not set to an instance of an object. at Umbraco.Forms.UI.Usercontrols.Installer.Page_Load(Object sender, EventArgs e)

    Does enyone know what what we should do to fix that? 

     

    Best regards Kimtho

    Copy Link

  • Comment author was deleted

    Nov 11, 2013 @ 11:36

    Contour should run fine, it just tries to update a value in the web.config.

    max request lenght (needs to be upped if you have large forms)

    http://our.umbraco.org/forum/core/general/39088-Maximum-request-length-exceeded-in-Contour-on-Upgrade-to-Umbraco-6

    Copy Link

  • This forum is in read-only mode while we transition to the new forum.

    You can continue this topic on the new forum by tapping the "Continue discussion" link below.

Please Sign in or register to post replies