Hey all, I have 2 installs of umbraco 4.5.2 and courier 1.3 installed, one is dev, the other is stg. I have courier 1.3 setup to transfer from dev to stg, and the node gets pushed, but the parentID is always set to -1 on stg for that node. Is there some configuration issue i'm missing?
The content is just a page content with tinyMCE editor box. I've looked at the raw xml from the umbraco.config in both dev and stg, and the only difference seems to be the parentID is -1.
Courier 1.3 setting ParentID=-1
Hey all, I have 2 installs of umbraco 4.5.2 and courier 1.3 installed, one is dev, the other is stg. I have courier 1.3 setup to transfer from dev to stg, and the node gets pushed, but the parentID is always set to -1 on stg for that node. Is there some configuration issue i'm missing?
The content is just a page content with tinyMCE editor box. I've looked at the raw xml from the umbraco.config in both dev and stg, and the only difference seems to be the parentID is -1.
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.