So I created a website in visual studios then published it to Azure. After publishing I went into the umbraco back office so that I could create a new document type. It was just a single MultiURLPicker so I could link an external page on the menu. However, when I generate models then look at my website it says Umbraco itself couldn't start and I have to restore my entire site from a backup to get it running again.
Generating Models crashes Umbraco 8
So I created a website in visual studios then published it to Azure. After publishing I went into the umbraco back office so that I could create a new document type. It was just a single MultiURLPicker so I could link an external page on the menu. However, when I generate models then look at my website it says Umbraco itself couldn't start and I have to restore my entire site from a backup to get it running again.
What can I do about this?
Could you copy and paste some error logs? Or if you have a 500 page could you paste a screenshot of it?
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.