Umbraco v10, Macro Parameter Editor, Single Media Picker Missing
For the default Macro Parameter Editors, I see:
Content Type Picker
Multiple Content Type Picker
Tab Picker
Multiple Tab Picker
Property Picker
Multiple Property Picker
Multiple Media Picker (version 3)
The only (Single) Media Picker is the legacy version, which according to the documentation isn't recommended for use.
Is this a mistake? Did v9 have the new Single Media Picker?
I'm just trying to figure out if I should use the legacy version before I get too deep in development (recreating a lot of functionality from a prior Umbraco v7 site).
Unfortunately, the editors you can use for a macro are very much limited. For now I would use the legacy picker because there is nothing else. You could also create custom macro property editors if you're up for it: https://our.umbraco.com/documentation/extending/macro-parameter-editors/.
Thanks, Luuk (and sorry taking so long to reply), that's what I wound up doing.
The lack of macro parameters is terribly frustrating (and always has been). Right now I'm trying to get Nested Content working in a Macro (used Søren Kottal's Parameter Editor Generator package in v7 to do this before) and it's not going great :-)
Umbraco v10, Macro Parameter Editor, Single Media Picker Missing
For the default Macro Parameter Editors, I see:
The only (Single) Media Picker is the legacy version, which according to the documentation isn't recommended for use.
Is this a mistake? Did v9 have the new Single Media Picker?
I'm just trying to figure out if I should use the legacy version before I get too deep in development (recreating a lot of functionality from a prior Umbraco v7 site).
Thanks, Wm
Unfortunately, the editors you can use for a macro are very much limited. For now I would use the legacy picker because there is nothing else. You could also create custom macro property editors if you're up for it: https://our.umbraco.com/documentation/extending/macro-parameter-editors/.
Thanks, Luuk (and sorry taking so long to reply), that's what I wound up doing.
The lack of macro parameters is terribly frustrating (and always has been). Right now I'm trying to get Nested Content working in a Macro (used Søren Kottal's Parameter Editor Generator package in v7 to do this before) and it's not going great :-)
We'll see.
-Wm
why don't macros support the core data type / editors?
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.