That sounds a bit odd - If you have not limited the picker to certain document or media types then it should show all possible selectable nodes - What does your configuration of the picker look like? And what version of Umbraco 7 are you seeing this described behavior on?
Empty list by default when using the Multinode Treepicker
Hi,
for some time I see that, when you have a property of type Multinode Treepicker, the list is empty by default when you open the multinode treepicker.
Then when you add a value to the search then you get the values.
When will this be fixed or how can we fix this manually?
/Michaël
Hi Michaël
That sounds a bit odd - If you have not limited the picker to certain document or media types then it should show all possible selectable nodes - What does your configuration of the picker look like? And what version of Umbraco 7 are you seeing this described behavior on?
/Jan
Hi Jan,
I have this issue in following versions:
7.4.1 7.4.3 7.5.4
It is limited to certain document types. Would that be the reason?
Below you can see the config of the data type:
And then in the content section when I open the picker its empty:
But if you start typing in the search, you get the results:
/Michaël
@Jan,
any ideas on this?
/Michaël
Ok I just have forked the latest version 7.5.5 of umbraco locally, run it and did the same thing.
Here the list is not empty and I se the results.
Is anything changed compare to previous versions?
/Michaël
Ok I have found the cause for this.
My parent container was set to listview. So with listview you get a empty list by default, if you remove the listview then you see the nodes.
Issue:
http://issues.umbraco.org/issue/U4-9183
Will make a PR for this!
/Michaël
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.