The UI for defining Member Types has been updated in 7.4.+ but the documentation screenshots haven't caught up yet!
So you can still create Tabs to store properties on for your custom Member Types:
It's not obvious if you are referring to the old screenshot, but the 'Add another tab' at the bottom of the new Member Type UI is what you are looking for:
Member Tabs?
I was reading the Members documentation (gasp) here:
https://our.umbraco.org/documentation/getting-started/data/members/
And I noticed that this has a "Tabs" tab and corresponding "setup" that appears to allow you to control what fields show up on one tab.
My question is, is this still supported, if so, where do you turn it on. If it isn't - does that mean that it is coming back or is to gone?
Hi John
The UI for defining Member Types has been updated in 7.4.+ but the documentation screenshots haven't caught up yet!
So you can still create Tabs to store properties on for your custom Member Types:
It's not obvious if you are referring to the old screenshot, but the 'Add another tab' at the bottom of the new Member Type UI is what you are looking for:
et voila...
regards
Marc
Makes sense, I wasn't sure if the docs were talking about perhaps an Umbraco content site page that could be controlled (wishful thinking) :-)
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.