Sign in Register
Copied to clipboard

Flag this post as spam?

This post will be reported to the moderators as potential spam to be looked at


  • Joe Qureshi 3 posts 73 karma points
    Jun 20, 2017 @ 20:01
    Joe Qureshi
    0

    Umbraco not publishing changes unless application pool reset.

    When I make any changes to even empty sites the changes only go through once I have reset the application pool.

    Setting fcnMode to disabled works, however it takes much longer than it should.

    This is a clean install, using visual studio -> IIS express on windows 10.

    Copy Link
  • Alex Skrypnyk 6182 posts 24283 karma points MVP 8x admin c-trib
    Jul 14, 2017 @ 10:42
    Alex Skrypnyk
    0

    Hi Joe

    What is the code of your page? Can you share views code?

    Maybe some macro caching?

    Thanks,

    Alex

    Copy Link
  • Alex Skrypnyk 6182 posts 24283 karma points MVP 8x admin c-trib
    Jul 17, 2017 @ 09:33
    Alex Skrypnyk
    0

    Hi Joe

    Did you find what was the problem?

    Alex

    Copy Link
  • Joe Qureshi 3 posts 73 karma points
    Jul 24, 2017 @ 13:43
    Joe Qureshi
    0

    Sorry for the late reply.

    I tried multiple fresh installs on a windows 10 virtual machine (parallels) using a shared drive.

    0 code was added and the problem persisted regardless of whether I was doing it on Windows/Mac side.

    I followed a few guides on using Visual Studio & IIS Express to make it so my Mac side could use the same localhost.

    In the end I stopped using Umbraco and switched to a different CMS.

    Copy Link
Please Sign in or register to post replies

Write your reply to:

Draft