Am sooooo close to releasing my first Umbraco site. Just trying to iron out a few issues, two of which are:
1. Content tree - if I add a new document, the content tree needs to be manually refreshed. Ideally from an end users perspective I would like it to show without then manually refreshing. Is this intended behaviour or is there something I can set to change this.
2. Content tree - after adding Blog4Umbraco (superb package) when navigating to the content section, the system automatically defaults to the blog where as I would like it to default to the home page.
Content tree
Hi,
Am sooooo close to releasing my first Umbraco site. Just trying to iron out a few issues, two of which are:
1. Content tree - if I add a new document, the content tree needs to be manually refreshed. Ideally from an end users perspective I would like it to show without then manually refreshing. Is this intended behaviour or is there something I can set to change this.
2. Content tree - after adding Blog4Umbraco (superb package) when navigating to the content section, the system automatically defaults to the blog where as I would like it to default to the home page.
Any suggestions would be much appreciated.
Thanks.
RE point 1: which version of Umbraco are you using? The tree behaves as you wish in 4.5.
Hi Darren,
I am using umbraco v 4.0.4.2 (Assembly version: 1.0.3811.17115)
I'll upgrade - thank you.
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.